Axel Oxygen 5 Spezifikationen PDF herunterladen (Seite 16)

Oxygen 5

Pag. 16

3.16 MODULE CONFIGURATION

On the MONO module board you find 10 Jumpers allowing different operation modes and functions.

To change a jumper setting, please:

• switch off the console (every intervention on the modules always requires the mixer switching off !)

• remove the module

• disconnect the flat cable (pay attention to the two little hooks placed at the connector edges)

• alter the setting position as showed by the following table

• connect again the flat cable and lock the hooks

• insert the module into the console mainframe

• turn on the console

Please refer to the following figure and to the ‘Factory preset jumper configuration’ chapter at the

end of this manual before altering jumper configurations.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

Keine Kommentare

Axel Oxygen 5 Spezifikationen Seite 16