Axel Oxygen 3 Bedienungsanleitung PDF herunterladen (Seite 6)

Oxygen 2

Pag. 6

• You can speak to the phone user through the microphone connected to the first channel (MicDJ-Line)

(even if neither CUE or PGM keys are pressed). Please note that every time you hook the line, you allow

the phone user to listen to the first channel output.

NOTE: if PGM key is selected on the TELEPHONE channel (no matter of the CUE keys), You are able to

speak to the phone user only by selecting the PGM key on the MIC channels, too.

4.3 MASTER CHANNEL

OUTPUT 2: it controls the signal level on the VARIABLE output.

BALANCE: it controls the signal balance on the VARIABLE and FIXED outputs.

4.4 TALK OVER SECTION

The TALK OVER section allows compression of all signals from CH 2 and from the

TELEPHONE channel in favour of CH1 channel signal. It means that you can, f.i.,

automatically fade the level of music signals (from Stereo module) depending on the level of

a microphone signal.

LEVEL: it controls the ratio of the compression: the lower is the value, the lower will be the

compressed audio level. The TALK OVER function can be disabled by turning the LEVEL

potentiometer in position 10.

THRESHOLD: the trimmer inside the hole adjusts the threshold intervention level of the

compressor (use a small screw-driver in order not to damage the trimmer).

RELEASE: adjusts the release time of compressor: the higher is the value (turn it

clockwise), the longer is the time needed to go back to the former audio level. (use a small

screw-driver not to damage the trimmer).

4.5 MONITOR CHANNEL

POWER: it switches On / Off the mixing console. The led in the key shows its status.

EXT: it adjusts the EXT IN input signal level (for example the tuner signal)

MON: it controls the level of the signal related to the MONITOR OUT (CUE or EXT IN, or

PGM).

PHONE LEVEL: it controls the headphones signal level. Phone signal is the same as

Monitor output

EXT: by pressing this key you relate the input EXT IN signal to the Monitor output

PGM: by pressing this key you relate the Master signal to the Monitor output

T.B.: by pressing this key you send the channel CH1 pre-fader signal to the TALK BACK

output.

NOTE: with released PGM and EXT IN buttons, the Monitor output supplies the PFL (CUE)

signal.

1 2 3 4 5 6 7 8

Keine Kommentare

Axel Oxygen 3 Bedienungsanleitung Seite 6