Oxygen 7Oxygen 7 - MONO MODULE
Pag. 19
7.7 MODULE OPTIONS AND JUMPER SETTINGS
The MONO module can be configured in a number of different ways
depending on the jumper options set on the JUMPER SET bay:
When closed, the A PHANTOM jumper allows for Phantom power on Input A
When using a phantom powered microphone, ensure that the mixer is
switched off when the microphone is plugged in to the XLR connector.
When closed, the LIMITER jumper enables a Limiter internal stage. The
purpose of the limiter is to provide control over the hottest peaks in the
signal. Limiter is not user-settable and acts when signal goes over 0 dB.
When closed, the NOISE GATE jumper enables an internal Noise Gate
circuit so that as the signal level drops below the -60dB threshold, the signal
is muted.
When closed, the TB (to) STUDIO-SUB jumper put the signal from the pre-
fade section of the module onto the TalkBack Studio audio Bus and allows it
to be output on the Studio Monitor section (see MONITOR module).
The major use of this facility is also that TB STUDIO bus feeds the
channels (see Slate/TB functions) and the Telco channels and will therefore
allow the Producer to talk to a telephone caller off-air. Please refer also to
TB Route settings on the Master Module.
When closed, the TB (to) C.ROOM jumper put the signal from the pre-fade
section of the module onto the TalkBack Ctrl Room audio Bus and allows it
to be output on the Control Room Monitor section (see MONITOR module).
The major use of this facility is the off-air communication from the Studio
(e.g. the presenter) and the Control Room. Please refer also to TB Route
settings on the Master Module.
When FADER ÙÙ START jumper is closed, moving the fader away from the
down position brings the module into the ON status and a Start command is
given (see Remote Interface). Moving the fader back to its down position
brings the module to OFF status. This jumper does not affect START button
operating.
When START ÙÙ FADER jumper is closed, press START button to activate
the module and provide a START command. Press START again to de-
activate it. ON/OFF status of the module is regardless of the Fader position.
When the START switch is not activated, the cha
without bringing the audio up and without generating a start command. The
channel can now be activated, by pressing the START switch (ON red led
will glow).
When closed, DUCK MIX jumper makes the signal from the pre-fade section
controlling the ducker circuit (with the module ON). The signal to be
attenuated by the ducker are determined by the local Duck switches. Please
refer to Chapter 6.
When the PFL MUTE VCA jumper is closed, the PFL key toggles the module
ON and OFF. In particular, when PFL is activated the module is OFF and
viceversa.
(19 Seiten)
(35 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern